The official Novation forum

novation impulse 49, Pro Tools 10

As the Novation community has developed over the years, it has naturally found the bulk of it's voice on Social Media. To ensure we can be there to discuss and support you as best we can, we’ve decided to close the forum.

The conversation isn’t over, though. We’re waiting for you; come say hi.

Also, be sure to check out some of our friends.

As ever, thank you for your support.

Thanks for reading, The Novation Team

If you're having a technical difficulty, get in touch via http://bit.ly/NovationSupport and our technicians will get back to you as soon as they can!

6 posts / 0 new
Last post
rendezvousblackswan
Offline
Last seen: 1 year 8 months ago
Joined: 12/11/2015 - 10:57
novation impulse 49, Pro Tools 10

Impulse controls instrument plugins in pro tools, with the automaps running in abortion mode. I've run in to problems during the software setup, however. Software stop up recognizes the 220 plugins at the first screen, yet, once I arrive at the end of the wizard stop, I'm left with the defeating report that Autorun cannot connect with Pro Tools... And I have no idea what steps I should take to troubleshoot.Help me, Obiwon...Pro Tools 10, Windows 8.1 Pro, Novation Impulse 49

 

 

 

 

skijumptoes
Offline
Last seen: 1 year 7 months ago
Joined: 03/26/2013 - 13:22

Did you upgrade pro tools?  If so this may apply:-

http://uk.novationmusic.com/answerbase/upgrading-pro-tools-with-automap-...

rendezvousblackswan
Offline
Last seen: 1 year 8 months ago
Joined: 12/11/2015 - 10:57

I've heard about this little trick here, and have tried it before, but I haven't been able to get any results. It actually isn't an upgrade. Perhaps I should just fully reinstall everything?

rendezvousblackswan
Offline
Last seen: 1 year 8 months ago
Joined: 12/11/2015 - 10:57

Alright, I've uninstalled Pro Tools, and disabled the RTAS plugins in Automaps... We'll see if it works this time....

rendezvousblackswan
Offline
Last seen: 1 year 8 months ago
Joined: 12/11/2015 - 10:57

Still ending up with a message that says, "Automaps did not connect to Pro Tools. I followed every instruction.... Now what? Lol at least I can still control some instruments in Pro Tools.... Just not the mixer. That's just no different than where I was at from the get go....

skijumptoes
Offline
Last seen: 1 year 7 months ago
Joined: 03/26/2013 - 13:22

You're probably best to contact Novation via the technical support page.  (On the left under Navigation menu)